Fisher & Paykel AeroSmart Series Installation Instructions And User Manual page 28

lnsta[lllati©n inst 'uctions
3-wire connections plus separate grounding connector
For use where local codes do not permit grounding through the Neutral wire.
Useapproved 3wife PowerSupply Cord or a 3--wireCable for Direct Wiring asdescribed on page 2X
A separate ]0AWG copper grounding wire is required,
Remove the terminal block cover plate,
Insert the power supply cable wkh a ULlisted strain relief through the hob provided in the cabinet
near the terminal biocL Do not tighten strain relief screw until wiring connections are complete.
Note a strain relief must be used
strain relief
clamp sections
3
4
S
Fig.27 Inserling
8he powercord
Remove center terminal block screw.
Remove appliance ground link by removing the ground connector screw (Green screw).
Connect a separate copper ground wire (green with yellow stripe) using the ground connector
screw (Green screw). Make sure a ring terminal is used when connecting the ground wire and that
the wire is firmly secured to an adequate grounding path.
S
Note: If the appliance is
moved back to a 3wire
installation the ground
link must be refitted,
\ Remove link 7
FYg,28 Connecting th_ wir_*s
Connect the neutral wire (center) of the power supply cord to the center terminal screw of the
terminal block.Tighten screw.
7 Connect the other wires to the upper and lower terminal block screws marked with the letter L
Tighten screws.
8 Refit terminal block cover by inserting the two tabs first on the rear panel of the dryer and secure
cover with securing screw
9 Tighten strain relief screws
8
.//j/
J
/
It is recommended that a qualified ,4ectriclan 1 ig.2g R_filting _ennind
delermine that the ground path is adequate ] block ond tightening screws