Table of Contents
Advertisement
Available languages
Available languages
Beloire you callll folr selrvice
If the lid is already dosed, open the lid and dose it again, then press START/PAUSE.
Disconnect
from the power (either by unplugging
the dryer or turning
off the circuit
breaker that supplies it). Wait 10 seconds, reconnect and try turning
it on again.
_,
The machine is unable to close the drum due to clothes interfering
with the
closing mechanism.
Remove any articles that are interfering
with the drum door
and dry these in the next load.
is your load higher than the top of the lint bucket7 Remove some articles and dry
these in the next load.
If your dryer is continually
beeping and a message is displayed
on the screen, a
fault has occurred
which requires repair from a Service Agent.
Pressing the POWER button once will stop the beeping but will still display the fault code. We
recommend
leaving the machine
in this mode as the fault code will enable the service person
to quickly
identify the cause of the problem.
Single beep every second and ...
3.
Check your machine
is level (refer to installation
instructions
pages 7 -- 31).
4.
S.
If the fault re--occurs repeat steps 1 and 2
If the machine still will not work, call your Fisher & Paykel Dealer or Authorised
Service Agent to
arrange service (refer to page 62).
Advertisement
Table of Contents
