Fisher & Paykel AeroSmart Series Installation Instructions And User Manual page 29

4,_wi_e co_ectio_s
Remove the terrninal block cover plate. _ 'i
Insert the power supply cable with a UL listed _train relief through the hole provided in the cabinet
near the terminal block Do not tighten strain relief screw until wiring connections are complete,
Note', a strain relief must be used,
sorrows
Remove center terminal block screw, ig._o Inserling lhe power cord
Remove appliance ground link by removing the ground connector screw (green screw),
3
4
I No_e:lf_he appliance is moved backtoa 3wire ]
lns_aJlationtha ground link must be lefi_ted.
]
Remove link ig._'/ Removing screws
S Connect ground wire (green) of the power supply cord to the ground conductor green screw,
Tighten screw,
_ Connect the neutral wire (white) of the power supply cord to the center terminal screw of the
terminal block Tighten screw,
7 Connect the red wire and black wire to the upper and lower terminal block screws marked with
the letter L Tighten screws
Fig._;2 Connect ng wiring
7 ¸
_ Refit terminal block cover by inserting the two tabs first on the rear panel of the dryer and
secure cover with securing screw,
(_ Tighten Strain Relief screws,
_t
Fig,33 Refitdng terminal block _nd screws