Fisher & Paykel AeroSmart Series Installation Instructions And User Manual page 14

¸il ¸liiii ¸il ¸liiiii ¸I ¸II ¸iiiil ¸ii i i iiiil ¸il ¸ii'i iiiiiii ¸il ¸iiiii:ii ¸iliiii'liiii ¸I ¸ii'iii iiii ¸I ¸ii iiiiiiil
lnstalllllation ilnstlructions
The dryer must be ve_ed to the outdoo_s_
Ose rigid or thick wall fle×iMe metal exhaust duct,
Oo _ot use a p_astic exhaust duct,
Do not use a meta_ foi_ exhaust duct.
Failure to follow these instructions can result in death or fire.
The dryer must be exhausted to the outdoors. This will prevent the build up of lint and moisture
in the room in which it is located and reduce the risk of fire.
This appliance must always be vented to the outdoors.
Exhaust ducting products can be purchased from your local Appliance store or Hardware store.
Plastic or metal foil flexible duct can kink, sag, be punctured, reduce airflow, extend drying
times and affect dryer operation.
A minimum of 4 inch (100 ram) thick wall flexible metal or rigid galvanised metal duct must be
used. Using ducts larger than 4 inches (100 mm) diameter may result in more lint accumulating.
Using straight rigid metal ducting will minimize lint accumulation. Thick wall flexible metal
ducting may be used but care must be exercised to avoid sharp bends which may squash the
duct and cause blockages. Do not use plastic ducting or thin wall flexible metal ducting
Use duct tape to secure joints. Do not use screws as they collect lint.
Keep ducting as short and straight as possible. Do not exceed the maximum exhaust duct
lengths stated later in these nstalJation nstructions.
Do not exhaust the dryer into any other duct, chimney or gas vent, a wall, a ceiling or any
concealed space in a building Do not exhaust the dryer under a house or mobile home or a
porch, or into a window well or other area that will accumulate lint.
The exhaust duct should end with an exhaust hood with a
swing out damper to prevent back drafts and entry of wild
life. Never use exhaust hoods with a magnetic damper The
hood should have at least 12 inches (305 mm) clearance
between the bottom of the hood and the ground or other
obstruction The hood opening should point down. Never
install a screen over the exhaust outlet.
_ig.9 Yxh_ust hood minimum
ground deoro,nce
,,,,,,,,,,,,,,,,,,,,,, i)