Fisher & Paykel AeroSmart Series Installation Instructions And User Manual page 24

nstalllBtion inst,ructions
Power supply cord requirements for U°SA (for electric models only)
Only a UL listed power--supply cord kit a suitable length for the installation and rated 120/240 V
rain, 30 A and marked with use for dothes dryers shall be used.
This shall have ring terminals to connect to the dryer.
The Ubrated strain relief included with it shall be suitable for a 1 1/8" (28.S mm) hole.
Fig_20 UL Ii£€*d power-supply cord
.................. ................ lJ
3 wire _ f
4 wire
Cormecdng by direct wire
Power supply cable must match power supply (4--wire or 3--wire) and be:
Flexible armoured or non--metallic sheathed copper cable (with ground wire), All current-
carrying wires must be insulated.
10 gauge A3b/Gsolid copper wire (do not use aluminium wire).
Suitable length for the installation,
A UL approved strain relief must be used.
Grounding for a direct wired appliance
This appliance must be connected to a grounded metal permanent wMng system, or an
equipment grounding conductor must be run with the circuit conductors and connected to the
equipment-grounding terminal on the appliance.