Fisher & Paykel AeroSmart Series Installation Instructions And User Manual page 23

Illnstalllllation instlructions E]
Electrical requirements for electric models only
Use a new UL approved 30-ampere power cord or direct wire came°
Use a UL approved strain relief.
Disconnect power before making e_ectrica_ connections,
Connect neutra_ wire (white or center wire) to center terminal
On aH four wire [ns_Hat[ons remove the grounding _ink and connect the
ground wire to the green ground connecting screw.
Connect remaining 2 supply wires to remaining 2 terminalso
Securely tighten a_m e_ectrica_ connections,,
Failure to do so can result [n death, fire, or electrical shock.
Note: The wiring diagram is located in the control console.
The dryer must be plugged into or connected to an individual branch circuit, do not use an
extension cord.
The power supply must be 220/240V or 208V, 60 Hz approved alternating current electrical
service.The electrical service requirements can be found on the data label that is located on the
splash back. A 30-ampere fuse or circuit breaker is required on each of the lines.
If a power cord is used, the cord must be plugged into a 30-ampere receptacle.
The power cord is NOT provided with U.S. electric model dryers.
This dryer is supplied with the cabinet grounded through the neutral on the terminal block.
If the dryer is to be nstaJled in (1) a new branch circuit installation, (2) a mobile home, (3) a
recreational vehicle, (4) an area where local codes do not permit grounding through the neutral
conductor, the appliance grounding link must be removed and a 4-wire power cord/cable or a
separate grounding wire must be used.
Do not reuse a power supply cord/cable from an old dryer. The power cord/cable electric supply
wiring must be retained at the dryer cabinet with a suitable UL listed strain relief.
208V requirements
if your power supply is 208V 60 Hz, a new element kit rnust be fitted by a qualified electrician or
service representative (see Accessories page 7 for kit part number).