Fisher & Paykel AeroSmart Series Installation Instructions And User Manual page 27

Illnstallllation inst,ructions E]
3
4
3_wi_e connections
For use where [oca[ codes permit grounding through the Neutra[ wire°
Use approved I--wire Power Supply Cord or a 3--wire CaNe for Direct Wiring as described on
page 23,
Remove the terminal block cover plate.
Insert the power cord with a UL listed strain relief through the hole provided in the cabinet near
the terminal block. Do not tighten strain relief screw until wiring connections are complete,
Note: a strain relief must be used,
strain relief
damp sections
SCreWS - --
Loosen or remove the center terminal block screw, Connect the neutral wire (center) of the
power supply cord to the center terminal screw of the terminal block, Tighten screw.
Connect the other wires to the upper and lower terminal block screws marked wth the letter L
Tighten screws,
4
3
Fig.24 Conneding lhe wires
_ Refit terminal block cover by inserting the two tabs first on the rear panel of the dryer, Secure
cover with securing screw.
6 Tighten strain relief screws,
Fig.25 Ref'ildng terminol blo k cover Fig.J* Tightening s_min relief screws