Exercise 7: Wire Searching; Introduction - ABB SmarTac Applications Manual

4.9 Exercise 7: wire searching

4.9.1 Introduction

About wire searching
Sometimes it is necessary to search with the welding wire, rather than the gas cup.
In some systems with the necessary optional hardware installed, this is possible.
The SmarTac instructions are designed to handle this. Search_1D and
Search_Part each have an optional argument, Wire, that will switch the signal
to the wire if selected. The instruction Search_Groove assumes that wire searching
capabilities are present.
Application manual - SmarTac
3HAC024845-001 Revision: A
© Copyright 2004-2016 ABB. All rights reserved.
4 User's guide
4.9.1 Introduction
69