Exercise 8: Searching For A Groove; Introduction - ABB SmarTac Applications Manual

4.10 Exercise 8: searching for a groove

4.10.1 Introduction

Example of weld seam
In heavy welding applications it is common to have groove type weld seams. The
simplest example is the square groove with a backing.
xx1400001517
Searching
In heavy welding tolerances are usually large so searching is critical in determining
the location and width of seams like the one above. The instruction Search_Groove
has been provided to satisfy this need.
See
Requirements for Search_Groove
Search_Groove performs a series of searches when executed. It requires two
robtargets. One is programmed outside the groove, and the other in the center of
the groove. It requires a displacement frame that will be returned as the seam
offset. It requires a number that will be returned as the actual width of the seam.
It also requires a nominal width, a speed, and a tool.
Application manual - SmarTac
3HAC024845-001 Revision: A
Note
Search_Groove - Find groove width and location on page
© Copyright 2004-2016 ABB. All rights reserved.
4 User's guide
4.10.1 Introduction
88.
Continues on next page
71