Table of Contents
Advertisement
Installation Instruction
6. If the cable is of dual coaxial type, then leave 12 mm of the outer screen
7. Strip 5 mm of the insulation from the ends of the inner conductors.
8. Prepare at least 25 mm of the screens by twisting them as shown in the
9. Attach both the screens and two jumpers (thin copper wires) to a single
Figure 49
10. Connect each wire to the terminal block of the OVP module, using a small
42
and strip 15 mm of the insulation of each conductor as shown in the figure
below.
figure below.
crimp terminal, as shown in the figure below.
Stripping Lengths
screwdriver (<2.5 mm) to open the terminal connectors. See relevant figure
below depending on the OVP variant used.
1/1531-COH 109 2073 Uen H 2006-11-06
Hide quick links:
Advertisement
Table of Contents
