Note: The four batteries to be installed are referred to as battery 1, 2, 3, or 4
2. Remove the protective caps of each battery.
3. Attach the adhesive pads, shown in the figure below, to the right-hand
Figure 31
4. Attach the temperature sensor holder to battery 2. Remove the inner part
Figure 32
Note: For each battery the rear strap end must be brought over the battery
5. Place battery 1 on the far left of the shelf.
1/1531-COH 109 2073 Uen H 2006-11-06
respectively. The numbers refer to the battery positions on the battery
shelf, where battery 1 is installed on the far left, followed by batteries 2,
3, and 4 in order. See Figure 34 on page 31.
sides of batteries 1 and 3.
Adhesive Pad Attachment
of the holder and attach it according to the figure below.
Temperature Sensor Holder
to the front.
Procedure
29