Table of Contents
Advertisement
3.7.3
Connecting Transmission Cables, Coaxial, 75
T3) - Alternative 3
Figure 54
To connect a coaxial cable to an Overvoltage Protection (OVP) module, do
the following:
1. Ensure that the DF is not fastened in place, and that the space beneath it is
2. Remove the rubber sealing in the DF cable entry closest to the OVP
3. Insert the cable with its cable gland (1) and tighten it with a 20 mm
Note: The cable is a dual coaxial cable, that is, the cable consists of two
1/1531-COH 109 2073 Uen H 2006-11-06
Possible OVP Module Positions
accessible. See Section 3.3 on page 10.
module to be used.
open-ended wrench (2). See figure below.
coaxial parts.
Procedure
, Unbalanced (E3,
45
Hide quick links:
Advertisement
Table of Contents
