Table of Contents
Advertisement
2. Remove the ACCU front cover, by unscrewing the three screws, using a T8
Figure 11
3. Route the power cable through the cable inlet as shown in the figure below.
4. Strip the cable sheath of the power cable to an appropriate length, using
5. Strip about 10 mm of the power cable conductors, using a wire stripper.
6. Connect the cable conductors to the terminal blocks. Tighten the screws to
7. Tighten the cable gland by hand.
1/1531-COH 109 2073 Uen H 2006-11-06
Torx screwdriver, and hook the plate off as shown in the figure below.
ACCU Front Cover Removal
cable shield cutters.
a torque of 5 Nm, using a torque wrench and a 5.5 mm flat bit.
Procedure
17
Hide quick links:
Advertisement
Table of Contents
