Magura Hs22 Brake Lever; Setting The Grip Distance On A; Magura Disc Brake Lever - Bosch BULLS Twenty 6 EVO Translation Of The Original Operating Instructions

6.5.4.2 Setting the grip distance on a

Magura HS22 brake lever

Only applies to pedelecs with this equipment
You can adjust the brake lever position (grip
distance) to your requirements.

Use a T25 TORX® wrench to turn the setting
screw (1) to adjust the grip distance.
Figure 55: Setting the grip distance on a Magura HS 33
brake lever

Pull the brake lever gently and hold.
 Move the slider (2) outwards (–) to Position II
or III.
 The brake handle moves closer to the
handlebars.
 The brake linings move closer to the rim.
 The pressure point activates sooner.
 Move the slider inwards (+) to Position II or I.
 The brake lever moves away from the
handlebars.
 The brake linings move away from the rim.
 The pressure point activates later.
WARNING
!
Crash caused by incorrectly set grip distance
If brake cylinders are set or installed incorrectly,
braking power may be lost completely at any time.
This may cause a crash with serious injuries.
 Once the grip distance has been set, check the
position of the brake cylinder. Correct if
necessary.
MY20B01 - 52_1.0_02.10.2019
6.5.4.3 Setting the grip distance on a

Magura disc brake lever

Only applies to pedelecs with this equipment
WARNING
!
Crash caused by incorrectly set grip distance
If brake cylinders are set incorrectly or installed
wrongly, the braking power may be lost at any
time. This may cause a crash with injuries.
 Ensure that the fully applied brake lever is at a
minimum distance of 20 mm from the
handlebars (4).
You can adjust the brake lever position (grip
distance) to your requirements. Such adjustment
does not affect the pressure point or the position
of the brake linings.

Use a T25 TORX® wrench to turn the setting
screw (1) to adjust the grip distance.
Figure 56: Setting the grip distance on a Magura disc
brake lever
 Turn the setting screw/twist knob (5) anti-
clockwise towards minus (–).
 The brake lever moves closer to the handlebar
grip.
 Turn the setting screw clockwise towards
plus (+).
 The brake lever moves away from the
handlebar grip.
Operation
53