Figure 53: Pulling the locking lever upwards; by.schulz
speedlifter used as an example
3 Pull out the handlebars to the required height.
4 Close the stem clamping lever.
6.5.3.2 Adjusting the quick release clamping
force
If the handlebar clamping lever stops before
reaching its end position, unscrew the knurled
nut.
Tighten the knurled nut on the seat post if the
seat post clamping lever's clamping force is not
effective enough.
If you are unable to set the clamping force, the
specialist dealer will need to check the quick
release.
6.5.4
Setting the brake
The brake lever grip distance can be adjusted to
ensure that it can be reached more easily. The
pressure point can also be adjusted to the rider's
preferences.
Contact your specialist dealer if there is no
description of your brake below.
MY20B01 - 52_1.0_02.10.2019
6.5.4.1 Setting the grip distance on a
Magura HS33 brake lever
Only applies to pedelecs with this equipment
You can adjust the brake lever position (grip
distance) to your requirements. Such adjustment
does not affect the pressure point or the position
of the brake linings.
Use a T25 TORX® wrench to turn the setting
screw (1) to adjust the grip distance.
2
Figure 54: Setting the grip distance on a Magura HS 33
brake lever
Turn the setting screw anti-clockwise towards
minus (–).
The brake lever moves closer to the handlebar
grip.
Turn the setting screw clockwise towards
plus (+).
The brake lever moves away from the
handlebar grip.
Operation
1
52