Inserting The Integrated Battery; Charging The Battery - Bosch BULLS Twenty 6 EVO Translation Of The Original Operating Instructions

1 Open battery lock with battery key (see [1]).
 The battery is released and falls into the
retainer guard (see [2]).
2 Hold the battery in your hand from below. Use
the other hand to push on the retainer guard
from above (see [3]).
 The battery is released and falls into the hand
(see [4]).
3 Remove the battery from the frame.
4 Remove the battery key from the battery lock.

6.11.3.2 Inserting the integrated battery

(1)
(2)
Figure 70: Inserting the integrated battery
1 Place the battery into the lower mount with the
contacts facing the front (see [1]).
2 Flip the battery up so that the battery is held by
the retainer guard (see [2]).
3 Push the battery upwards (see [3]).
 There is an audible clicking noise.
4 Check battery to ensure it is firmly in place.
5 Lock the battery with the battery key;
otherwise, the battery may fall out of the mount
when you open the lock (see [4]).
6 Remove the battery key from the battery lock.
7 Check the battery to ensure it is firmly in place.
MY20B01 - 52_1.0_02.10.2019
(4)
(3)

6.11.4 Charging the battery

CAUTION
!
Fire caused by overheated charger
The charger heats up when charging the battery. In
case of insufficient cooling, this can result in fire or
burns to the hands.
 Never use the charger on a highly flammable
surface (e.g. paper, carpet etc.).
 Never cover the charger during the charging
process.
 Never leave battery unattended during charging.
Electric shock caused by penetration by water
If water penetrates into the charger, there is a risk of
electric shock.
 Never charge the battery outdoors.
Electric shock in case of damage
Damaged chargers, cables and plug connectors
increase the risk of electric shock.
 Check the charger, cable and plug connector
before each use. Never use a damaged charger.
Notice
If an error occurs during the charging process, a
system message is displayed.
 Remove the charger and battery from
operation immediately and follow the
instructions.

The ambient temperature during the charging
process must be within the range from 0 °C to
40 °C.

The battery can remain on the pedelec or can be
removed for charging.

Interrupting the charging process does not
damage the battery.
1 Remove the cable connection cover if
necessary.
2 Connect the mains plug of the charger to a
normal domestic, grounded socket.
Connection data
Operation
230 V, 50 Hz
66