Electric Drive System; Switching On The Electric Drive System; Switching Off The Drive System - Bosch BULLS Twenty 6 EVO Translation Of The Original Operating Instructions

6.12

Electric drive system

6.12.1 Switching on the electric drive
system
CAUTION
!
Crash caused by lack of readiness for braking
When it is switched on, the drive system can be
activated by the application of force on the
pedals. There is a risk of a crash if the drive is
activated unintentionally, and the brake is not
reached.
 Never start the electric drive system, or switch
it off immediately, if the brake cannot be
reached safely and reliably.

A sufficiently charged battery has been inserted
into the pedelec.

The battery is firmly positioned. The battery key
has been removed.
There are three options for switching on the drive
system.
On-Off button (battery)
 Press the On-Off button (battery) briefly.
On-Off button (display)
 Press the On-Off button (display) once.
Switched-on display
 If the display is already switched on when it is
inserted into its mount, the electric drive
system is switched on automatically.
 After switching on, a speed of 0 K M / H is
displayed on the display. If it is not, check
whether the display screen is fully engaged into
position.
 If the drive system is switched on, the drive is
activated as soon as the pedals are moved with
sufficient force (except if in push assist mode
or the level of assistance is "OFF").
 The motor power is determined by the level of
assistance set on the display.
 As soon as the system has been activated,
A C T I V E L I N E / P E R F O R M A N C E L I N E
appears briefly on the display.
MY20B01 - 52_1.0_02.10.2019

6.12.2 Switching off the drive system

As soon as you stop pushing the pedals in normal
mode or reach a speed of 25 km/h, the drive
system switches off the assistance system. The
assistance system starts up again if you push the
pedals and your speed is less than 25 km/h.
The system switches off automatically ten minutes
after the last command. There are three options
for switching off the drive system manually.
On-Off button (display)
 Press the On-Off button (display) once.
On-Off button (battery)
 Press the On-Off button (battery).
Removing the display
 Remove the display from the mount.
 The LEDs on the operating status and battery
level indicator go out.
Operation
68