Black Box 10BASE-T Manual page 19

Hide thumbs Also See for 10BASE-T:

Table of Contents

10BASE-T EXTENDER

To Single UTP

Punchdown Block

Figure 3-10. Connected patch cable.

1. Form a loop at the end of each patch cable wire and place the loop under the

lip of a pin. Position the punchdown tool over the pin, with the cutting edge

above the short end of the wire, and press down firmly. The tool forces the

wire down between the halves of the forked pin and severs its short end

(Figure 3-11).

Table of Contents

Troubleshooting