Table of Contents
Advertisement
INITIAL INSTALLATION
4b.
Secure mounting bracket (C) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
NOTE: It is very important you use the proper
hardware when installing the mounting bracket
(C) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is
installed facing the higher point of the ceiling, and
ensure the ceiling angle is not steeper than 19º.
5. Remove preassembled motor screws (S) and
washers (T) from underside of motor housing (D). If
there are plastic motor blocks installed with the
motor screws (S), discard the plastic motor blocks.
Note: Make sure to keep loose hardware separate
to avoid confusion during installation.
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 9.
DOWNROD-STYLE FAN MOUNTING
1.
Remove pin (V) and clip (W) from downrod (A).
Partially loosen preassembled set screws and nuts
in motor housing yoke at top of motor housing (D).
4b
STANDARD
MOUNT
C
5
Plastic
Motor
Block
1
W
Yoke
D
7
ANGLE
MOUNT
C
Open End
S
T
A
V
Set Screw
and Nut
D
Advertisement
Table of Contents
