Downrod-Style Fan Mounting - Harbor Breeze RLG52NWZ5L Manual

INITIAL INSTALLATION
5. Remove preassembled motor screws (J) and lock
washers (K) from underside of motor housing (D).
If there are plastic motor blocks installed with the
motor screws (J), discard the plastic motor blocks.
Note: Make sure to keep loose hardware separate
to avoid confusion during installation.
For DOWNROD-STYLE FAN MOUNTING,
proceed to Step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 10.

DOWNROD-STYLE FAN MOUNTING

1. Remove pin (L) and clip (M) from downrod (A).
Partially loosen preassembled set screws and
nuts in motor housing yoke at top of motor
housing (D).
2. Insert downrod (A) through canopy (B). Thread
wires from motor housing (D) up through
downrod (A).
5
D
1
M
Yoke
D
2
B
8
J
K
A
L
Set Screw
& Nut
Plastic
Motor
Block
A