INITIAL INSTALLATION
5.
Remove motor screw/washers (S) from
underside of motor housing (D) and save for
blade arm attachment later on. [If there are
plastic motor blocks installed with the motor
screws/washers (S), discard the plastic motor
blocks.]
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1a below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 9.
DOWNROD-STYLE FAN MOUNTING
1a.
Remove pin (N) and clip (O) from downrod (A).
1b.
Partially loosen preassembled set screw and nut
in yoke at top of motor housing (D).
2.
Insert downrod (A) through canopy (B) and yoke
cover (E).Thread wires from motor housing (D) up
through downrod (A).
5
Motor
Block
1a
O
D
2
B
7
1b
A
N
Set Screw
& Nut
Yoke
E
S
D
A