ITEM #0076253 CLASSIC STYLE CEILING FAN MODEL #00819 UL MODEL #CSS36 Harbor Breeze ® is a registered trademark of LF, LLC. All Rights Reserved. Español p. 18 ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-643-0067, 8 a.m.
TABLE OF CONTENTS SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS Safety Information....................... 3 Please read and understand this entire manual before attempting to assemble, operate or install the product. Package Contents....................... 4 • When using an existing outlet box, be sure the box is securely attached to the building structure and can support the full weight of the fan, so as to avoid potential serious injury or death.
INITIAL INSTALLATION INITIAL INSTALLATION 4. Install the mounting bracket (A) to the outlet 1. Determine mounting method to use. box (not included), sliding the mounting bracket (A) over A - Downrod Mount (normal or angled ceiling) outlet box the two outlet box screws (not included). Securely tighten B - Closemount (normal ceiling only) the two outlet box screws.
DOWNROD STYLE FAN MOUNTING CLOSEMOUNT STYLE FAN MOUNTING 3. Loosen the two set screws from the yoke on 2. Remove every other screw from the top of motor the top of the motor housing (G). Slip downrod housing (G) and save. assembly (D) into housing yoke, aligning holes in clip downrod assembly (D) and yoke.
WIRING FINAL INSTALLATION Supply circuit 1. Connect the BLACK and BLUE wires from fan to 2. Install the two screws that were removed in previous step the house BLACK wire. Connect the WHITE wire and tighten securely. from fan to the house WHITE wire. Connect all screw outlet box GROUNDED (GREEN) wires together from fan to...
Page 7
FINAL INSTALLATION FINAL INSTALLATION 5. Fasten the blade bracket (E) to the motor by inserting 8. Remove the plug from the center hole in the switch the alignment post into the slot on the bottom of the housing cover (I). motor housing (G) and tightening the blade bracket screws with washers.
FINAL INSTALLATION FINAL INSTALLATION 11. Connect the white wire from the light kit (J) to the white 14. Remove the rubber washer, hex nut, bowl cap (L) and wire from the switch housing (H). Connect the black wire from the light kit (J) to the blue wire from the switch housing (H).
4. Turn power off. Carefully loosen 5. Fan too close to vaulted ceiling. canopy; remount securely. 5. Lower fan or move it to another location. Printed in China Harbor Breeze is a registered ® trademark of LF, LLC. All rights reserved. Lowes.com/harborbreeze Lowes.com/harborbreeze...
Need help?
Do you have a question about the CLASSIC STYLE 00819 and is the answer not in the manual?
Questions and answers