Assembly Instructions; Downrod Style Fan Mounting - Harbor Breeze 00892 User Manual

ASSEMBLY INSTRUCTIONS

1. Determine mounting method to use.
A - Downrod Mount (standard or angled ceiling)
B - Closemount (normal ceiling only)
IMPORTANT: lf using the angle mount, check
to make sure the ceiling angle is not steeper
than 20°.
2. Remove the rubber motor stoppers (O) from
the bottom of the fan motor assembly (G)
by loosening the three screws. Discard the
rubber motor stopper and screws.
3. Remove the mounting bracket (A) from the
canopy (B) by loosening the four screws
on the top of the canopy (B). Remove the
two non-slotted screws and save, then
loosen the slotted screws. This will enable
you to remove the mounting bracket (A).
1
A
B
2
G
3
Loosen but
do not remove
A
Remove
and save
B
6
ASSEMBLY INSTRUCTIONS
4. Install the mounting bracket (A) to the outlet box
(not included), sliding the mounting bracket (A)
over the two outlet box screws (not included).
Securely tighten the two outlet box screws.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (A) is
installed facing the ceiling.
Follow mounting instructions for "Downrod
Style Fan Mounting" or "Closemount Style
Fan Mounting", depending on mounting
method (A or B) chosen in step 1 on previous
page.

DOWNROD STYLE FAN MOUNTING

1. Remove pin and clip from downrod assembly
(D) and save.
O
2. Insert downrod assembly (D) through
canopy (B), canopy cover (C). Thread
wires from the motor housing assembly (G)
through downrod (D).
4
1
clip
pin
2
B
D
7
Outlet
box
A
D
C