Downrod-Style Fan Mounting - Harbor Breeze AFTONSHIRE Manual

INITIAL INSTALLATION
5. Secure mounting bracket (B) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket
(B) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (B) is
installed facing the higher point of the ceiling, and
ensure the ceiling angle is not steeper than 19°.
For DOWNROD-STYLE FAN MOUNTING,
proceed to Step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 10.

DOWNROD-STYLE FAN MOUNTING

1a.
Remove pin (J) and clip (K) from downrod (A).
1b.
Partially loosen preassembled set screws and nut
in yoke at top of motor housing (E).
Insert downrod (A) through yoke cover (D) and
2.
canopy (C). Thread wires from motor housing
(E) up through downrod (A).
5
B
1a
K
E
2
C
8
ANGLE
STANDARD
MOUNT
MOUNT
B
1b
A
J
Set Screw
& Nut
Yoke
Open End
A
D