Reset Procedure - King gates ROLLS Instructions And Warnings For Installation And Use

- In standby mode, the LEDs shows the current error type with a
series of regular flashes according to the following scheme:
Number of Error description
flashes per
series
1 On-board memory fault
Photo-test of safety devices failed. See Para-
2
graph 4.1 for solving the problem.
Automation's movement programming re-
3
quired. See Paragraph 6.
Input "S1 Edge" set as a resistive edge and
4 check failed. See Paragraph 13.4 for solving
the problem.
5 Power limit threshold
6 Obstacle detection due to encoder
7 Obstacle detection due to current
9.

RESET procedure

Reset procedure deletes door travel parameters (par. 6) and all ad-
vanced functions (par. 11). It can be performed in case of program-
ming mistakes and it brings the STAR GDO control board back to
factory settings.
This reset doesn't affect memorized radio transmitters (see par. 5
for radio trasmitters management).
ACTION
STEP
PRESS THE START
1 BUTTON FOR 8
SECONDS
RELEASE THE
2
BUTTON
PRESS THE START
3 BUTTON FOR 3
SECONDS
RESET IS NOW
4
COMPLETED
A NEW PROGRAMMING
5
OF THE AUTOMATION'S
MOVEMENTS IS REQUIRED
RESULT
All LED flash
START
All LED continue to flash
All LED light up in series
The red "ERROR" LED
lights flashes 3 times
continuosly
45