Connection Options - Kessel KTP 300 Installation, Operation And Maintenance Manual

The KESSEL submersible pumps KTP 300, 500 1000 with fully automatic float switch control can
be used as a basement sump pump to dewater basements. In the case that the pump is to be
permanently installed in a sump pit, the installation of a DN 50 conduit allows for proper power
chord installation and also serves as sump pit ventilation in the case that the sump pit is cover-
ed / sealed. Removal of the pump for use elsewhere is always possible.
50er HT-Rohr
Ein
Aus
1. Quick release coupling connection
1 1 / ''
4
2. Reducer connection from
1 ½ inch to 1 ¼ inch
3. Rotatable 1 inch hose connection
zum Kanal
In the case that the KTP 500 is to be used in a per-
CAUTION:
manent application, the body of the pump must be
ventilated. As seen in the KTP 500 illustration there is
a recessed hole on the pump body which should be
drilled out with a 6mm drill bit – this also goes for the
KTP 300 which requires a 4mm drill bit (see illustrati-
on). Be sure to only drill through the pump housing,
do not drill too deep as you may damage the pump.

2. Connection Options

vertical connection - KTP 500/1000
vertical connection - KTP 500/1000
vertical connection - KTP 300 only
1. Application
KTP 500
KTP 300
horizontal connection - KTP 500 only
horizontal connection - KTP 500 only
horizontal connection - KTP 300 only
18