Sas2Ircu Message That Raid Volume Sizes Other Than Max Are Not Supported (Cr 6983210) - Sun Oracle Netra SPARC T4-1B Product Notes

Under these conditions, the server module displays these error message and you are
unable to reboot from the device.
Installing boot information
WARNING: Could not update system for automatic rebooting
On previous servers and server modules, the OBP diag-device parameter used to
set the new device path to the boot device when the diag-switch? parameter was
set to true. On SPARC and Netra SPARC T4 servers and server modules, the
diag-device parameter is no longer supported, and the Oracle Solaris OS installer
warns that setting the OBP boot-device parameter is not possible.
Workaround: From the Oracle ILOM prompt, set the OBP diag-switch? parameter
to false.
-> set /HOST/bootmode script="setenv diag-switch? false"
Alternatively, you can set this parameter at the OBP ok prompt.
ok setenv diag-switch? false
sas2ircu Message That RAID Volume Sizes
Other Than MAX Are Not Supported
(CR 6983210)
If you attempt to create a RAID volume smaller than MAX, the following series of
messages is returned:
You are about to create an IR volume.
WARNING: Proceeding with this operation may cause data loss or data
corruption. Are you sure you want to proceed (YES/NO)? yes
WARNING: Volume created with size other than 'MAX' is not supported.
Do you want to continue with volume creation (YES/NO)? n
SAS2IRCU: you must answer "YES" or "yes" to proceed; operation aborted!
SAS2IRCU: Error executing command CREATE.
RAID volumes smaller than MAX are not supported. However, if you want to create
a volume below MAX size for nonproduction use, the software allows you to do so.
This situation is not clear from the message.
- Installing boot blocks (cxtxdxsx)
- Installing boot blocks (/dev/rdsk/cxtxdxsx)
- Updating system firmware for automatic rebooting
Known Product Issues 21