3Com CoreBuilder 9000 ATM Interface Module Quick Start Manual page 42

42 ATM I M
NTERFACE ODULE
Fast Setup Utility
==================
The current configuration will be displayed below;
Update if needed, and then hit Enter.
To move between sections, enter the following characters at end of line:
< > - Back and forth in sections
$ - To end of setup
Network Prefix
--------------
Current Switch Network Prefix : N/A
*** The following is an example for a legal Network Prefix
Next reboot Switch Network Prefix
Q S G
UICK TART UIDE
To begin the Integrated Fast Setup process, select the menu item:
(9) FST: Fast Setup by entering 9 at the prompt.
The following message appears on the screen.
Changes made to the configuration are implemented only after the
system is rebooted.
Network Prefix Section
This section prompts you for the Switch Module Network Prefix. Enter the
appropriate value in Hex. The following example shows a typical Network
Prefix.
47.00.00.00.00.00.3c.00.00.a*
: 47.00.00.00.00.00.3c.00.0b.*
\ - Back to beginning of setup