3Com CoreBuilder 9000 ATM Interface Module Quick Start Manual page 35

ATM Interface Module Software Download
To preform the ATM Interface Module Software download use the
following instructions:
1 Log into the CoreBuilder 9000 LMA. See "Starting Up" on page 38 for
complete log in instructions.
2 Set the download flag to 1 entering the command, 1 1 3 at the Main
Menu prompt.
3 Reboot the CoreBuilder 9000 by entering the command, 1 7 at the Main
Menu prompt.
4 Wait until the "AFTER DOWNLOAD (go to MON)" message is displayed,
then change the baud rate to 57600
5 Press Enter twice.
6 After the "=>" prompt is displayed, type dm 43 and press "Enter".
7 Set the modem type to "XMODEM".
8 Download the "Cb9ifc.cel" file.
9 After the "=>" prompt is displayed, change the baud rate to 9600.
10 Reboot the CoreBuilder 9000 by switching the power off and then back
on.
TFTP Upgrade Instructions
This section describes the procedure used to download software via TFTP.
ATM Interface and Switch Fabric Modules Software Download To
download software for the CoreBuilder 9000 ATM Interface Module or
for the ATM Switch Fabric Module, use the following procedure.
1 Log into the CoreBuilder 9000 Enterprise ATM Switch Local Management
Access (LMA) See "Starting Up" on page 38 for complete log in
instructions.
2 Perform TFTP download of SWM Application SW 1.2FB (Cb9swm.cel) by
entering the command, 1 3 2 at the Main Menu prompt.
3 Perform TFTP download of IFC Application SW 1.22 (Cb9ifc.cel) by
entering the command, 1 3 2 at the Main Menu prompt.
35