3Com CoreBuilder 9000 ATM Interface Module Quick Start Manual page 34

34 ATM I M
NTERFACE ODULE
Q S G
UICK TART UIDE
ATM Switch Fabric Module Monitor Download
To download the ATM Switch Fabric Module Monitor software, use the
following procedure:
1 Wait until the "AFTER DOWNLOAD (go to MON)" message is displayed,
then change the baud rate to 57600.
2 Press "Enter" twice.
3 After the "=>" prompt is displayed, type dm 60 and press "Enter".
4 Set the modem type to "XMODEM".
5 Download the "Cb9mon.cel" file.
6 After the "=>" prompt is displayed, change the baud rate to 9600.
7 Reboot the CoreBuilder 9000 by switching the power off and then back
on.
ATM Switch Fabric Module Software Download
To preform the ATM Switch Fabric Module software download:
1 Log into the CoreBuilder 9000 Enterprise ATM Switch Local Management
Access (LMA) See "Starting Up" on page 38 for complete log in
instructions.
2 Set the download flag to 1 entering the command, 1 1 3 at the Main
Menu prompt.
3 Reboot the CoreBuilder 9000 by entering the command, 1 7 at the Main
Menu prompt.
4 Wait until the "AFTER DOWNLOAD (go to MON)" message is displayed,
then change the baud rate to 57600.
5 Press "Enter" twice.
6 After the "=>" prompt is displayed, type do and press "Enter".
7 Set the modem type to "XMODEM".
8 Download the "Cb9swm.cel" file.
9 Skip to the next section if Interface Module software download is also
required.
10 After the "=>" prompt is displayed, change the baud rate to 9600.
11 Reboot the CoreBuilder 9000 by switching the power off and then back
on.