Table of Contents
Advertisement
14
ATM I
M
NTERFACE
ODULE
Removing the
OC-3/STM-1
Daughter Card
Q
S
G
UICK
TART
UIDE
8 To secure the daughter card, insert the three flathead countersink phillips
screws into the faceplate of the ATM Interface Carrier Module (Figure 8).
Insert the screws in the following order:
a Center of daughter card
b Right of daughter card
c Left of daughter card
Figure 8 Securing the Daughter Card
This section describes how to remove the OC-3/STM-1 daughter card.
Equipment Required
To remove the OC-3/STM-1 card you need:
A #1 phillips-head screw driver
The anti-static bag that the OC-3/STM-1 card was shipped in
The protective plate (if you are removing and not replacing the
module)
Advertisement
Table of Contents
Need help?
Do you have a question about the CoreBuilder 9000 ATM Interface Module and is the answer not in the manual?
Questions and answers