Table of Contents
Advertisement
Removal Instructions
To remove the OC-3/STM-1 card:
1 Remove the three countersink phillips screws from the faceplate
(Figure 9) using a #1 phillips-head screwdriver in the following order:
a Right of daughter card
b Left of daughter card
c Center of daughter card
Save the screws for future use.
Figure 9 Removing the Countersink Screws
2 Remove the screws and washers from the top of the OC-3/STM-1 card
(Figure 10). Put the screws and washers in the part bag that the screws
and washers were shipped in.
Figure 10 Removing the Screws and Washers
15
Advertisement
Table of Contents
Need help?
Do you have a question about the CoreBuilder 9000 ATM Interface Module and is the answer not in the manual?
Questions and answers