Table of Contents
Advertisement
11
Installation Procedure
There are four spacer posts on the ATM Interface Carrier Module to
support the daughter cards. Two spacers are located directly behind the
left cutout and two are located directly behind the right cutout (Figure 4).
Figure 4 Spacers
Spacers
Do not remove the spacers from the ATM Interface Carrier Module.
To install the OC-3/STM-1 daughter card in the left cutout, perform the
following procedure:
1 Hold the card at a 20° angle to the ATM Interface Carrier Module with
the protective plugs facing forward and the beige connector on the
bottom.
Advertisement
Table of Contents
Need help?
Do you have a question about the CoreBuilder 9000 ATM Interface Module and is the answer not in the manual?
Questions and answers