Setup Procedure Sections; Entering Data; Navigation Aids - 3Com CoreBuilder 9000 ATM Interface Module Quick Start Manual

40 ATM I M
NTERFACE ODULE
Q S G
UICK TART UIDE
For further explanation of the LMA menus and menu structure, see the
CoreBuilder 9000 Enterprise ATM Switch User Guide. The next section
takes you through a step-by-step process of the Intergrated Fast Setup.

Setup Procedure Sections

Table 7 lists the steps or sections of the Integrated Fast Setup.
Table 7 integrated Fast Setup Procedure Sections
Setup Section
1 IP and Management
Configuration
2 Network Prefix
3 LECS Address
4 UNI/NNI parameters
5 Confirmation

Entering Data

The Integrated Fast Setup procedure runs sequentially through the
relevant data for all of the sections, displaying a prompt for each data
item and a default value. If you wish to change the default, type the
desired value in place of the default and press Enter. If you wish to accept
the default, press Enter.

Navigation Aids

Table 8 lists the short-cut characters you can use to move between
sections of the Integrated Fast Setup procedure:
Table 8 Integrated Fast Setup Procedure Navigation Aids
Type: To perform:
< Go back to previous section.
> Proceed to next section.
>S Go to section indicated by double underlined ID letter S in section
title.
\ Go back to beginning of setup.
$ Proceed directly to end of setup.
Description
Set IP address of the switch, address of the NMS
application, default gateway address, and subnet mask
This section is relevant if a PCMCIA Ethernet Interface
Card is installed.
Set Network Prefix for the CoreBuilder 9000 Enterprise
ATM Switch
Set active LECS address for the CoreBuilder 9000
Enterprise ATM Switch
Set UNI/NNI port parameters for ports in the ATM
Interface Module Card
Confirm setup operation