Installing An Sfp - Avaya AA1419043-E6 Installation Manual

SFP
Model
100BASE-FX

Installing an SFP

Install an SFP to provide an interface between the device and the network cable.
Before you begin
• Verify that the SFP is the correct model for your network configuration.
• Before you install the optical connector, ensure it is clean.
Warning:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables connect to a
light source.
Electrostatic alert:
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Caution:
Risk of equipment damage
Only trained personnel can install this product.
About this task
Installing an SFP takes approximately three minutes.
32 Installation — SFP Hardware Components
Supported on ROHS product
the 9024XL number
10GB card
No AA1419063-E6
No AA1419064-E6
No AA1419065-E6
No AA1419066-E6
No AA1419067-E6
No AA1419068-E6
No AA1419074-E6
Comments? infodev@avaya.com
Description
1510 nm, up to 70 km
1530 nm, up to 70 km
1550 nm, up to 70 km
1570 nm, up to 70 km
1590 nm, up to 70 km
1610 nm, up to 70 km
1310nm, up to 2km
December 2012