Functions; Stand-Alone - SHOWTEC LED Powerbrick Set Product Manual

FUNCTIONS:

There are 3 options to operate the LED Powerbrick:
After completing your settings, be sure to unplug the Powerbricks and the controller, otherwise errors could
occur.
This way you reset the entire system, but your settings keep stored in the memory of the controller.

Stand-alone

1. The device will start test-mode.
2. Press MODE button to enter mode setting.
3. Switch to System Mode, then press the Set Up-button.
4. Enter the amount of tubes you are using.
5. For Stand-alone you have to use DMX Channel: 0, then press the Set Up-button again.
6. The LCD now shows "Set Address
or YES (=Up-Button) to store your choice. The LED Tubes will light up.
7. Now your unit is a stand-alone. You will find all the pre-programmed scenes below.
Menu
1. Static RED
2. Static GREEN
3. Static YELLOW
4. Static BLUE
5. Static PURPLE
6. Static CYAN
7. Static WHITE
8. Color Change
9. Flow 1 (FF)
10. Flow 2 (REW)
11. Flow 3 (FF/REW)
12. 2 Color Chase
13. Multi-Color Chase
14. Fade Change
15. 2 Color Fade Chase
16. Auto Run
17. System Mode
When "Function Set" appears in the LCD, then you are able to make some extra settings: Dimmer, Run
Speed, Flash Freq, etc.
YES"; press SETUP-Button (=NO) to keep your previous settings,
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Function Set
Stand-alone
Master / Slave
DMX Mode
7