Table of Contents
Advertisement
PC REQUIREMENTS FOR THE CALL RECORDER VOIP SOFTWARE
Windows Vista/7/8/10 , Intel Pentium >2GHz , 4GByte RAM , >100 MB free disk space.
1. Connect the V-Tap VoIP to a free USB port on your PC.
NOTE: The V-Tap VoIP must be connected to the same PC, otherwise the installer will not continue.
2. Software installation
•
Place the CD-ROM in your computer and the software installation starts automatically. In case the
installation does not start automatically, locate the file 'CRVoIPInstall.exe' on the CD and start it
manually. The following window appears:
•
Select your preferred language for the installation and press OK.
•
The menu will ask for an installation key, please enter:
•
Now you can proceed with the next steps of the installation and you will be asked to confirm the
locations on your hard drive where to store the software and the data files.
NOTE: A separate installation of the WinPcap driver may be needed and is started automatically,
depending on the absence of this low-level network interface driver.
To setup the CR-VoIP software to receive data from a V-Tap, go to Options, Setup, Recording tab:
•
NOTE1: The PC's IP address must be entered as the "Tunnel Server Address" in the V-Tap unit.
NOTE2: The PC's firewall must be open for TCP port 2016, the "Tunnel Destination Port" in the V-Tap unit.
NOTE3: The Encryption password must be the same as the "Tunnel Encryption Password" in the V-Tap unit.
NOTE4: The CR-VoIP software itself does not need channel licenses to receive from the V-Tap unit.
V1.6
Quick Guide for the V-Tap VoIP
CALL RECORDER VOIP SOFTWARE INSTALLATION
© 2017-2018 Vidicode
V-TAP
3
Advertisement
Table of Contents
Need help?
Do you have a question about the V-Tap VoIP and is the answer not in the manual?
Questions and answers