Thales Mobile Mapper User Manual page 117

This opens a new dialog box in which you should
define a name, a datum, a projection and other
parameters for this zone (see example below).
- Then click
OK
- Click again to close the
OK
log box.
- Click again to close the Coordinate System dialog
OK
box and make the newly defined system the currently
used coordinate system in MobileMapper Office.
Note: Although MobileMapper Office allows you to
create new coordinate systems and datums, you can-
not upload them to the receiver. This is done to pre-
serve the maximum amount of receiver memory for
data collection. However, creating new coordinate
systems and datums on MobileMapper Office will
allow you to compare the data you collect in the field
with exiting GIS data sets all in the same system/
datum.
to close this dialog box.
Grid System Definition
dia-
111