IBM Power Systems 9009-41A Manual page 47
System backplane
Hide thumbs
Also See for Power Systems 9009-41A:
- Manual (194 pages) ,
- Site and hardware planning (164 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Figure 30. Removing the NVMe M.2 carrier card
c) Place the NVMe M.2 carrier card on an appropriate ESD surface.
11. Remove the internal RDX docking station, if present. Otherwise, continue with step "12" on page
35.
a) Disconnect the RDX power cable (A) from the back of the RDX docking station and route the cable
over the side of the system as shown in the following figure.
b) Disconnect the front USB cable (B) from the back of the RDX docking station and route the cable
over the side of the system as shown in the following figure.
Removing and replacing the system backplane in the 9009-41A, 9009-42A, or 9223-42H 33
Advertisement
Table of Contents
