IBM Power Systems 9009-41A Manual page 118
System backplane
Hide thumbs
Also See for Power Systems 9009-41A:
- Manual (194 pages) ,
- Site and hardware planning (164 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Figure 103. Replacing the rear USB cable into the system
b) Route the cable along the right side of the chassis. Do not plug the other end of the rear USB cable
into the connector on the system backplane until directed in a later step.
19. Replace the service processor card.
a) Align the service processor card into PCIe location and push the card straight down into the slot
using two brackets (A) and (B), as shown in the following figure.
104 Power Systems: System backplane
Advertisement
Table of Contents
