Wiznet W5300E01-ARM User Manual page 32

5. Configuring Development Environment
Development environment is same as one which is generally usede. Programming is done at the Host PC.
Execution file for target board is created by using cross compiler. The file is sent to target board for execution.
5.1. Cable Connection
As shown in <Figure 5-1>, connect the Host PC and W5300E01-ARM board. The Linux should be installed
in the Host PC. Serial cable is used for system console, debugging and data transmission. UTP cable is for
data transmission. The data communication through UTP cable is faster than serial cable. In order to transfer
big-sized file, use UTP cable for more efficiency.
If you are not familiar with Linux, it is possible to develop at the Windows, and compile the source code by
sending to Host PC as shown in <Figure 5-2>.
Figure 5-1 : Cable Connection Example 1
Figure 5-2 : Cable Connection Example 2
© Copyright 2008 WIZnet Co., Inc. All rights reserved.
24