Table of Contents
Advertisement
5.
Execute AX1 at the PC.
6.
For the exact testing, calculate CPU Tick by selecting 'CPUTICK' -> 'CPUTICK' of AX1.
7.
Select 'TCP' -> 'Connect' of AX1.
8.
Input 'IP > 192.168.1.53' and 'PORT > 5001' and click 'OK' button.
The IP address of PC in which AX1 is installed, should be set as 192.168.1.xxx (Ex> 192.168.1.2).
9.
Check if 'Connected' message is shown. If PC and W5300E01-ARM board is connected, 'loopback start!'
message is displayed at the loopback program of W5300E01-ARM. If connection is not normal, check
below.
Is UTP cable correctly connected?
Is IP address correctly configured as 192.168.1.xxx?
Is loopback program normally executed at the W5300E01-ARM?
10. Select '∞' Toolbar of AX1, and select any image file. (Size : 10~50Mb)
Figure 4-8 : Loopback Connection Check
Figure 4-9 : Loopback Test
© Copyright 2008 WIZnet Co., Inc. All rights reserved.
23
Advertisement
Table of Contents
