Advertisement
Quick Links
Table of Contents
WizFi310 Quick Start Guide
WizFi310 Evaluation Board
Start Serial to Wi-Fi
2019/12/08 10:09
.........................................................................................................................
............................................................................................................................
.......................................................................................................................................
1/1
1
1
2
WizFi310 Quick Start Guide
Advertisement
Related Manuals for Wiznet WizFi310
Summary of Contents for Wiznet WizFi310
- Page 1 Table of Contents WizFi310 Quick Start Guide ......................... WizFi310 Evaluation Board ..........................Start Serial to Wi-Fi ............................2019/12/08 10:09 WizFi310 Quick Start Guide...
- Page 2 WizFi310 Quick Start Guide WizFi310 Evaluation Board The WizFi310 EVB is the evalution board for testing WizFi310 and prototyping development. WizFi310 EVB is composed of a WizFi310 evalution board and WizFi310 module. Feature Identification Button Description WizFi310 Reset Through this button, user can restart WizFi310 module.
- Page 3 Start Serial to Wi-Fi This chapter describes how to set WizFi310 in order to exchange data with peer system. This picture shows the environment for testing Serial to Wi-Fi example. In this example, WizFi310 is set to TCP server and peer system is set to TCP client.
- Page 4 This section explains how to connect to AP by using serial command. The default value which module will start is command mode so user can input AT command. If you input the AT commands as below, WizFi310 will connect to AP and then start TCP server. In the example, AP is set like that. ( SSID : WizFiDemoAP, Security : WAP2, Key :...
- Page 5 If it is done successfully, Mode LED will be on because WizFi310 is set to <data mode>. For more detailed information about <data mode>, refer to <Command mode & Data mode> In order to exit data mode or enter into command mode again, You have to send a single '+++' string without CR or LF (0x0D, 0x0A) - just the three (0x2B = '+') characters.
- Page 6 From: http://wizwiki.net/wiki/ Document Wiki Permanent link: http://wizwiki.net/wiki/doku.php/products:wizfi310:wizfi310qsg:start Last update: 2016/05/11 16:21 2019/12/08 10:09 WizFi310 Quick Start Guide...