Table of Contents
Advertisement
4.2. Testing Network Operation
W5300E01-ARM board supports Hybrid mode of W5300 linux driver – simultaneous use of S/W & H/W
TCP/IP stack. By configuring channel 0 as MAC_RAW mode, it is possible to utilize Hybrid mode for
compatibility with existing network program. Channel 1 is configured for testing looback test through H/W
TCP/IP stack.
By configuring channel 0 as MAC_RAW mode, existing network program can be supported without any
change. And, if there is any network application requiring higher performance, you can use other H/W
TCP/IP channels.
According to the requirement of your products, Hybrid mode can be useful. For more detail, refer to 'W5300
Datasheet'.
When W5300E01-ARM board is booted, FTP server, HTTP server and Telnet server are automatically
loaded.
4.2.1.
Testing FTP Server
1.
Supply the power to W5300E01-ARM and check booting is normally processed.
2.
Execute FTP Client program.
Windows : Start -> 'Run' -> input 'ftp'
Linux : Input 'ftp' at the terminal
3.
Input 'open 192.168.1.53' and connect to FTP server of W5300E01-ARM.
4.
Log in with 'id > wiznet, password > wiznet'.
Figure 4-5 : FTP Server Test
© Copyright 2008 WIZnet Co., Inc. All rights reserved.
20
Advertisement
Table of Contents
