1. Environment setting There are two types of WizFi360-EVB, which can be classified as ‘Shield’ and ‘Mini’ versions. WizFi360 is controlled by sending AT command through UART. WizFi360-EVB-Mini and WizFi360-EVB-Shield uses UART1 by connecting Micro USB. WizFi360-EVB-Mini WizFi360-EVB-Shield In addition, WizFi360-EVB-Shield is Pin compatible with Arduino. So you can use UART in two cases. If you use Micro USB, turn SW1 ON and connect Micro USB.
Page 5
If WizFi360-EVB-Shield or WizFi360-EVB-Mini is connected to a PC with a Mini USB Cable, run the serial program for UART communication on the PC. Open Port in Serial Program and input AT. If WizFi360 return OK, AT command can be used. WizFi360 Quick Start Guide...
Page 6
2. TCP Client Example A brief AT command describe for operating of WizFi360 as TCP Client in single connection mode. If you need AT command example of another mode, see the documentation called "AT command examples". 1. Set WizFi Station mode Request AT+CWMODE_CUR=1 //Station mode, in case of AT+CWMODE_DEF, it is stored in...
Page 7
7. Open TCP Server from PC which is connected to the same WiFi AP that WizFi360 is connected to. - Ex) IP : 192.168.10.100 Port : 5000 8. WizFi360 connects to the TCP Server as a TCP Client Request AT+CIPSTART="TCP","192.168.10.100",5000 //protocol, server IP, port Response CONNECT...
Page 8
11. End the TCP Connection Request AT+CIPCLOSE Response CLOSED WizFi360 Quick Start Guide...