Table of Contents
Advertisement
4.1.2.
Booting Check for Linux
At the Linux, the booting can be checked by using minicom.
Execute 'minicom –s' and select 'Serial port setup' menu, and configure the port as above.
Select 'Save setup as dfl' menu to save serial configuration. By selecting 'Exit' menu, exit the configuration
menu.
The device file of 'Serial Device' can be different according to the Linux version.
Turn on the board after connecting the board to PC by using serial cable, and executing the Hyper Terminal
program. If below booting message is displayed on the Terminal screen, the board normally operates.
Below screen means that the booting is processed to Bootloader and Linux Kernel, and user can use the
Linux.
If below booting message is not displayed, check if power adaptor or serial cable is normally
connected.
Figure 4-3 : Minicom Port Configuration
© Copyright 2008 WIZnet Co., Inc. All rights reserved.
18
Advertisement
Table of Contents
