Creating Groups
The 301C controller accepts a variety of transmitter models with a
variety of gas sensors. It can organize the data conveniently using
groups and events. However, the group logic requires that all of the
members of the group be from the same transmitter models and the
same sensor type. Mixing dissimilar sensors or transmitters in a group
can cause incorrect results.
Use the arrows to move the cursor to a group line and press Enter
The field can be edited when the brackets stop blinking and the
word "end" blinks
Use the up or down arrows to scroll through the list of all units
connected to the 301C controller, until the desired address is dis‐
played.
Press Enter again to validate the address.
The address is added to the group and the <end> bracket is shift‐
ed one position to the right.
Do not add duplicate copies of a transmitter.
The process can be repeated until all the desired transmitters in the
group (up to 126) have been added. The address for each transmitter
added in the Tx Info menu is available when creating groups.
Note: Groups created in the Groups menu will appear in the product
type list (Tx Info - Ident screen) as "Group xx" (the number
assigned to the group when it was created).
38