Assembling/Disassembling/Emptying The Dust Collection Box; Switching The Finishing Sander On And Off - Westfalia 81 80 48 Instruction Manual

 Depending on grain size there are degrees of coarseness.
The coarseness is specified by a number on the back of the
papers. The higher the number is, the finer the grain.
 It is important to use the right paper for each job. For rough
sanding use grain sizes up to 80, for soft wood as larch, pine
or spruce use papers from 120 to 150. For dense hardwood
as beech or maple, the grain sizes up to 220 can be used.
Assembling/Disassembling/Emptying the Dust Collection
Box
Always use the dust collection box (9) when sanding.
1. Place the dust collection box (9) onto the provided exhaust
connection. Push the box up to the end into the housing.
2. To remove the dust
collection box, just
pull the
wards.
clean the dust collec-
tion box
exhaust
in the housing after each use. By doing
this the dust collection box can be easily inserted and re-
moved.
3. For emptying the dust collection box, just tap out or, if
available, clean with compressed air.

Switching the Finishing Sander ON and OFF

1. To switch on the machine, depress the ON/OFF trigger (1).
2. For locking the ON/OFF trigger, push the locking button (2) in
the handgrip, while holding the ON/OFF trigger in the "ON"
position.
Operation
box out-
Preferably
and the
connection
11