Setting The Sanding Belt; Assembly/Disassembly/Emptying The Dust Collection Box - Westfalia 84 36 70 Original Instructions Manual

2. Next, place the sanding belt over the guides and the adjustable
drum (14). Make sure the arrow printed on the inside of the sanding
belt corresponds with the direction of the arrow marked on the ma-
chine housing (16).
3. Adjust the sanding belt so that it sits evenly over both rollers. En-
sure it is correctly centred.
4. To tense the sanding belt for use, push the tension lever (15) back
into place.

Setting the Sanding Belt

The sanding belt must lie flush with the plate and be firmly tensioned
across the sanding plate. It should not hand below it. If this occurs, the
belt with the wrong dimension may have been used.
1. If the sanding belt does not run true, use the fine adjustment screw
(7) to adjust the belt, so that it is correctly aligned.
2. Turn the machine over and use the adjusting screw to centre the
belt until it runs true to the edge of the guide. Make sure the belt
cannot cut into the housing or the guide.
3. Regularly check whether the belt is still running true, adjust if nec-
essary.
Assembling/Disassembling/Emptying the Dust Collection Box
Always use the dust collection box (4) and if possible the dust extrac-
tion adaptor (12), particularly when sanding painted surfaces.
Dust Extraction with Dust Collection Box
1. Place the dust collection box (4) onto the exhaust connection.
2. To remove the dust collection box, just pull the box outwards. Open
the dust collection box to empty.
Dust Extraction with the Dust Extraction Adaptor
1. Insert the two pieces dust extraction adaptor into the housing.
2. Push the hose of a suitable dust extraction device (e. g. a powerful
vacuum cleaner) into the adaptor.
Hint:
Operation
17