Switch-To-Defaults - THOMSON SpeedTouch 610 Operation And Maintenance Manual

9 Resetting the SpeedTouch™610

9.4 Switch-to-Defaults

Introduction
Procedure
68
In some rare situations you may not be able to reset the SpeedTouch™610 via any of
the methods described in the previous sections.
This may be in situations where:
•
The SpeedTouch™610 System password is forgotten
• An uploaded configuration file locks up the SpeedTouch™610, even after
restarting the device.
In these cases the SpeedTouch™610 offers a hardware method to completely revert
the device to its default state.
To reset the SpeedTouch™610 via a Switch-to-Defaults:
Make sure that the SpeedTouch™610 is powered on.
1
On the SpeedTouch™610 back panel a set of DIP switches can be found (See the
2
SpeedTouch™610 Orientation Guide
ber 4 in the UP position:
You will notice that the PWR/Alarm LED flashes red.
3
Power cycle the SpeedTouch™610 (Power off - Power on).
4
After restart the SpeedTouch™610 will come online with factory defaults.
5
Reset the DIP switch in its original position. If not, the 'PWR/Alarm' LED will flash
6
red as a warning.
After a reset to factory defaults a reconfiguration of the SpeedTouch™610 IP address
might be necessary.
for more information). Put DIP switch num-
E-SIT-CTC-20030324-0002 v1.0